Transtec 2019 NEW Drone LED Light Bar Board EASY Button Programmable lampSwitch drone RC Quadcopter Spare Parts | Игрушки и хобби

Transtec 2019 NEW Drone LED Light Bar Board EASY Button Programmable lampSwitch drone RC Quadcopter Spare Parts | Игрушки и хобби

Transtec 2019 NEW Drone LED Light Bar LED Light Bar Board EASY Button Programmable lamp Switch drone RC Quadcopter Spare Parts   Specification:   4 lights in a strip* 10PCS : 33mm*6mm (light strips can be cut directly from the tail end) MCU control panel: 44mm*18mm  Net weight: 0.0085g, Package Weight: 0.046g   Easy way for light on/ off / colors switch by just manually press one button.   1. the light is on when power up. 2. Press (K1) for 2 seconds to enter the color setting (all lights flash), pass the switch (K1, K2 to switch the color); after switching the color, press and hold (K1) for 2 seconds to save & exit the current mode. 3. Press (K2) for 2 seconds to enter the brightness setting (all lights flash twice), K1 controls brightness +, K2 controls brightness - ; after adjusting the brightness, press and hold (K2) for 2 seconds to save & exit the current mode. 4. Press K1 for 4 seconds to enter sleep mode (lights off). When you need to illuminate the light, just press K1 slightly.   In the color setting mode, if you exit the current mode without saving, the brightness could not be adjusted. In the brightness setting mode, if you exit the current mode without saving, the color could not be set.   After setting the brightness or color, you need to save it. Otherwise it will not save the last operation after powering up again next time. The Buttons K1 and K2 are on the taillight board (6 panel).   Motherboard: Input power: 6-30V input Output: 5V/5A   4 light board: Voltage: 5V Working current: 90MA    recommed to install capacitor.